Build an Adirondack chair By Les Kenny[Table of contents are below]
8. Add the back boards
Tilt the chair back
Use a bucket, a container, or anything that is slightly more than 300mm high, to use as a support for the chair.
Tilt the chair back and rest the middle rail on the support.
This makes it easy to fix the back boards to the rails.
Apply some glue to the rails and then lay the back boards on the rails beginning with the two center boards and screw them in place. Run the bottom of the back boards just slightly below the bottom rail. Look at the image above for screw placement.
The chair thus far
When the back boards are fixed to the rails, you can take the props off and stand the chair upright.
TABLE OF CONTENTS
Page 01 Measurements, Materials list, required tools, the wood, The parts
Page 02 Cutting all the pieces to length
Page 03 Cutting the seat slats
Page 04 Cutting the back boards
Page 05 Shaping the sides
Page 06 Marking the seat curve
Page 07 Marking the seat curve (photos)
Page 08 Marking, cutting, the middle rail
Page 09 Marking and cutting the bottom rail, the arms, and corbel
Page 11 Adding the bottom rail
Page 12 Adding the legs, props, and corbels
Page 13 Adding the arms and middle rail to the mix
Page 14 Adding the back boards
Page 15 Preparing and adding the seat slats
Page 16 Shaping the back
Page 17 Photos. Touch up and sand
Page 18 Photo. Not a bad chair eh?
• User Comments/photos