Build an Adirondack chair By Les Kenny[Table of contents are below]
Step 6. Add the legs, props, and corbels
6.1. Add the legs
From the front of the two side pieces, measure 240mm along the bottom and make a mark. Call it point 'L'.
Refer to the drawing below.
Then draw a line up from point L, 15 degrees off square.
You can use a protractor to get the angle. Refer to the drawing for a visual reference.
Glue and clamp the legs to the side pieces.
Make sure that the back edge of each leg is on the drawn line.
The leg should run 141mm below the bottom of the side piece from 'point L'.
Then fix each leg to its respective side with five screws.
6.2. Add the props
A prop is the same height as a leg. It is a temporary piece clamped to the rear of a side piece.
Its purpose is to hold the arm/middle rail configuration up in apposition until such time as the back boards are fixed in place.
Clamp the prop to the side piece parallel to the leg.
The back edge of the prop and the back edge of the leg should be 350mm apart.
6.3. Add the corbels
Draw a center line down the face of the leg. Run it down from the top about 200mm which is the length of the corbel.
Also mark the center on the top edge of the leg and the center of the width on the top end of the corbel.
Do just as is shown in the drawing.
On the center line of the leg, Mark three points down, 50mm apart. The first will be 50mm down from the top.
Drill screw holes through those three points. The drill size should be the same thickness as the screw shank.
Put some glue on the long edge of the corbel and clamp it to the leg. Ensure the center marks on top of the corbel and the leg line up and the tops of the corbel and leg are flush.
Fix by screwing.
TABLE OF CONTENTS
Page 01 Measurements, Materials list, required tools, the wood, The parts
Page 02 Cutting all the pieces to length
Page 03 Cutting the seat slats
Page 04 Cutting the back boards
Page 05 Shaping the sides
Page 06 Marking the seat curve
Page 07 Marking the seat curve (photos)
Page 08 Marking, cutting, the middle rail
Page 09 Marking and cutting the bottom rail, the arms, and corbel
Page 11 Adding the bottom rail
Page 12 Adding the legs, props, and corbels
Page 13 Adding the arms and middle rail to the mix
Page 14 Adding the back boards
Page 15 Preparing and adding the seat slats
Page 16 Shaping the back
Page 17 Photos. Touch up and sand
Page 18 Photo. Not a bad chair eh?
• User Comments/photos